RuleMate Automatic Bilge Pump 12V/24V - 50L/min - 800GPH

All in one bilge pump and switch - no need for independent float switch.

The innovative design incorporates the bilge pump and water sensor in one single housing.

Rule's unique sponge ability feature leaves the bilge drier then ever. When water in the bilge reached a certain height the solid state sensor automatically activates and the pump runs until the water is pumped out, reducing boat weight, saving fuel and minimizing bilge odour.

Pump check feature - simply touch the pump check button on the pump, hold for a few seconds to test cycle the pump.

Pump has a threaded discharge port with O ring seal and are supplied with both 90 degree and straight hose port - 20mm.

Available in 12 or 24 volt.

3 year limited warranty.

• 800GPH at open flow / 640GPH at 1 metre head
• More compact size - only 2/3 the size of the previous versions
• Auto-sense intelligence fully automatic water level sensing
• Fully automatic pump in 1 common compact housing
• Pump and sensor are internally common wired for easy installation
• No battery drain other than when the pump is in use
• Optimized impeller design gives up to 10% higher flow than previous versions - at the same amperage
• Built-in thermal cut-out (TCO) to protect the pump & the vessel
• Supplied with back flow prevention - check valve in outlet port
• Anti-Airlock design has hidden air vents in the pump body
• Safety back-up operating mode prevents continuous running if the sensor or impeller is fouled by debris
• Pump check feature - touch and hold for 5 seconds on the "touch here" button on the pump casing - to instantly check the operation of the pump
• Removable strainer to access impeller area to clear any debris
• 3rd wire allows for manual over-ride using a Rule switch panel
• Overall dimensions including straight hose port 190mm Length x 80mm Wide x 115mm Height
• 1.5 amp draw at 12v DC
• 4amp fuse

Spare Parts Available:

SP856 Replacement Snap-On Strainer

SP843 Straight threaded port suits 20mm (3/4") hose (as supplied with pump)

SP844 90 degree threaded port suits 20mm (3/4") hose

SP845 Straight threaded port suits 25mm (1") hose

SP846 90 degree threaded port suits 25mm (1")

SP852 Replacement check valve 20mm (3/4")

SP853 Replacement check valve 25mm (1")